How to install the No Theft GPS 4G Tracking Unit

The Backup battery and antenna are inside the case. Tools you may use to perform the installation: Screwdrivers, Wire strippers and cutters, Crimping tool, Voltmeter. Additional materials you might use: Connectors, Tape, Zip Ties For basic operation, connections are required to constant Power (+12V) and solid constant Ground. To enable optional Tow Alerts, a connection to an Ignition Signal is required. Connecting Constant +12V Power (Red wire) First, use the multi-meter to find a source of CONSTANT +12V near the ignition switch. Using your preferred connector type, or solder, connect the RED wire from the tracker to the source of +12V. The power is constant regardless of the ignition switch position. Connecting Ground (Black wire) The black wire must be connected to a source of chassis ground. This can be either another grounded wire, or a clean metal connection to the chassis of the vehicle.

Connecting the Starter Interrupt The Green wire provides power to the relay. Use the 30 amp relay and socket to wire into the starter wire. Locate the starter wire and cut it. Wire the one end to 87 and the other to 30 of the relay. 85 to a solid ground and 86 is connected to the Green wire from the GPS unit. . Testing the installation When the harness is connected to Power and Ground, the device will power up. Two lights will begin flashing – one is green and one is orange. The green light indicates operation of the GPS module. It flashes while establishing a connection to the satellites. Once it gets a “fix”, the light stops blinking and glows constantly. Test in an open area like a parking lot or street, as the roof of a garage or building will block the signal. In normal conditions, it may take up to 15 minutes for the device to get a GPS fix.The orange light indicates operation of the Cellular module . It will blink slowly while seeking a connection, then quickly as it makes the connection and when communicating. When it has a connection but is not communicating, the light will be solid. Mounting the 4G LTE GPS tracking device in a hidden location. The GPS device is intended to be inside the cabin of a vehicle or heavy equipment, and is not waterproof. It is not designed to be mounted externally or in the engine compartment. The GPS device contains internal Cellular and GPS antennas, so the location and orientation of the device is important for reliable tracking. The location should be somewhere such that no metal is between the device and the sky. A typical location is behind the instrument panel. You can mount the device using zip ties, placement direction is noted on the label. Conceal and secure the wires of the harness, and trim or bundle up unused wires. Make sure that wires can't fall into view. areas of the vehicle and be tugged. Make sure that they are not in locations where they may be damaged b-y the operation of pedals, g-love boxes, fans, heaters, etc. Please call your support team at 888-668-4338, from 9-5 Mon-Fri Pacific time. Thank you!